Umbrella stands are an essential household accessory to organize and store wet umbrellas, and also to keep entryways safe by helping keep floors dry. Umbrella holders may also function as a beautiful decorative accent for the foyer or entryway making a significant first impression on visitors. While www.excellentaccents.com could be constructed of any material, solid brass and copper umbrella holders have the main benefit of excellent corrosion resistance, durability, and sweetness. During the 1970s and early 1980s, brass and copper umbrella holders were a well known decorative accent for homeowners with imported brass umbrella holders from England, Italy, and India topping the list. Today, these stands can be obtained at yard sales, antique stores, and web-based for a fraction of their original cost. A number of these vintage umbrella holders can be returned to their original beauty using simple techniques.
Is My Umbrella Stand Solid Brass or Plated Brass?
Plated brass or plated copper umbrella holders can be difficult to re-finish since the finish is simply a thin coat of brass or copper applied over steel sheet metal. Once the thin plated finish has rusted or corroded, the underlying steel material is exposed making the conclusion subject to further corrosion and discoloration. Plated brass or copper plated stands can be simply detected using a magnet. If the magnet sticks towards the stand, it is a plated piece. On the contrary, solid brass or solid copper umbrella stands can be simply re-finished because solid brass or solid copper could be polished indefinitely without further damage or discoloration.
Refinishing your stand.
If your solid brass or solid copper umbrella stand is still bright in appearance, but shows wear as a result of marks or scratches, it could be coated using a thin lacquer. It will probably be essential to take away the lacquer before polishing the stand by using a household paint/lacquer remover. If your umbrella stand already appears tarnished, chances are that no lacquer exists and also the stand could be cleaned and polished without additional preparation. For cleaning and polishing any solid brass or solid copper umbrella stand, a brass or copper polish paste is a superb solution. From your experience, Wenol Brass Polish is a wonderful choice and can be found in many hardware stores or ordered online. Apply the polish to your soft cloth (gloves recommended) and rub the cloth on the umbrella stand beginning from the base up. Once the stand is polished you can use it “as it is” and it will develop a slight patina as time passes. If you want the are in position to remain highly polished it will likely be necessary to apply a thin coat of clear lacquer. Clear spray lacquer is accessible at most hardware stores and paint centers. Use care never to spray over fingerprints when the stand is polished as fingerprints could become more obvious once the stand is lacquered.
For small home or apartment use, a holder with a diameter of eight inches is normally adequate to keep as much as four umbrellas if the umbrellas are certainly not tightly wrapped. For home of office use, a holder using a diameter of nine inches is actually a popular choice and is also normally adequate to store from four to seven umbrellas if the umbrellas usually are not tightly wrapped. To get a agfacf office, a diameter of ten inches or maybe more is normally required. Typically of thumb, a stand having a larger diameter is a lot more resistant against tipover. A diamter of nine inches or greater is right for use in a public area. A regular height for umbrella receptacles for house or office use is twenty inches or taller. Where full-sized umbrellas are encountered, as in a large office or public area, a receptable should be a minimum of twenty inches tall.